So why do you need a transmission temperature gauge? Watch this video to find out! Highlights include:

*At 0:15, we explain the different situations in which you may need a trans temp gauge.

In this video, we tell you about the gauges that we installed in our project Integra. Highlights include:

*At 0:59, we talk about the specific gauges we chose and why.

*At 1:46, we talk about gauge accessories, such as sandwich adapters for oil lines.

*At 2:36, we begin our gauges installation.

*At 3:25, we install some gauges in our GlowShift gauge bezel.

*At 6:12, we show you how we installed our boost vacuum gauge's sending unit under the hood.

*At 7:12, we install our oil filter sandwich adapter so that we can get an accurate oil pressure and temperature reading.

*At 10:10, we install our water temperature sending unit.

*At 15:20, we show you the results of our efforts - a slew of new performance gauges!

In this video, we go over the ins and outs of aftermarket gauges. Highlights include:

*At 0:38, we explain why aftermarket gauges are usually more accurate, and therefore more useful, than factory gauges.

*At 0:48, we talk about air/fuel ratio gauges.

*At 2:14, we talk about boost gauges.

*At 2:30, we tell you about boost vacuum gauges.

*At 2:42, we go over fuel pressure gauges.

*At 2:56, we talk about oil pressure gauges.

*At 3:07, we talkabout oil temperature gauges.

*At 3:28, we tell you about water temperature gauges.

*At 3:40, we talk about tachometers.

*At 4:02, we talk about voltmeters and amp gauges.

*At 4:28, we go over exhaust gas temperature gauges.

*At 4:44, we offer our opinion of the most critical gauges to get for your vehicle.

*At 5:08, we tell you about the different types, styles and sizes of gauges available, including mechanical, electric, analog, and digital.

In this video, we show you a typical installation of aftermarket gauges into a diesel truck. Highlights include:

*At 0:36, we tell you which gauges we chose for our installation, and why.

*At 2:22, we get started with the installation of our gauges, beginning with our exhaust gas temperature gauge sending unit.

*At 3:53, we begin the installation of our transmission temperature gauge sending unit.

*At 4:55, we install our boost gauge sending unit

*At 6:50, we run our sending unit wires inside the cab of the truck so that we can hook up our gauges.

*At 8:50, we show you how to tie your gauge wiring into your fuse block.

At 12:45, we install our GlowShift gauge pod.

*At 14:00, we finally hook up the gauges themselves.

*At 14:42, we turn on our new gauges for the first time!